2022年台北國際食品加工機械展-攤位N-0901
展覽地點
台北南港展覽館1館4樓 (地址：台北市南港區經貿二路1號)
展覽日期
2022年6月22至24日(星期三至星期五) 上午10時至下午6時2022年6月25日(星期六)上午10時至下午5時
Blickle wheels are part of an offshore project for the power supply of Stockholm Heavy duty wheel made of cast nylon GSPO600/100PR The customer... builds and operates high voltage and low voltage systems and provides power for roads, rails, and air traffic systems throughout Norway and Sweden. The core business of the company is to design, assemble, control, maintain and repair power systems. The company has his head office in Norway and around 350 employees. The applicationThe application area of the wheel is an under roller for a high voltage cable on a 4x7m cable drum. The untwisted cable will later be laid in a submarine system and is therefore extra-long and heavy. Therefore, it was very important for the customer that the wheels carry up to 20 tons of load. As the working environment is mainly outdoors and close to the ocean, another requirement of the customer was that the wheels withstand the wet, salty air and cold Swedish winter temperatures. In order to keep the extremely tight schedule, it was aggravating that the proposal could not be suffi ciently tested.
Our solution from the standard rangeDue to the high load capacity requirements, the Blickle experts recommended the heavy duty wheels made of cast nylon GSPO600/100PR. The highly abrasion resistant wheel also suitable for use at high temperatures below freezing.The resultBlickle’s exceptional service and detailed advice convinced the customer. With timely delivery, the wheels are now an important part of a submarine offshore project that will provide high voltage power to the entire Stockholm area.
Reliable transport for heaviest loads Heavy duty wheel GB 340x200/75F7-295-921579 The customer... is located in the south of Sweden. Their engineers have been active in the machine building industry for over 30 years, especially in the press industry, the automotive, aerospace and wind power industries. Core competence is lifting, turning and transport of heavy and geometrically demanding loads. Single transport carts as well as single machines and complete flow production lines are produced. The challengeThe machine manufacturer produces electric vehicles for the transport of extremely heavy loads up to 500 tons. Some of these vehicles are possible to use as AGVs (automated guided vehicles).
For the steering of his vehicles, the customer has developed a customized wheel which is used as drive wheel inside these vehicles. Depending on the type of transport platform, one to four drive wheels are used. These are designed to carry heavy loads at low speeds (approximately 3–4 km/h). The electrical vehicles are normally operating indoors on an even concrete floor. Important requirements for this application are a compact design and a high load capacity.
For some years, a wheel was used that did not meet the quality requirements. The manufacturing of the wheel was divided into two steps, receiving the parts from two suppliers, one for the wheel centre and one for the Vulkollan® tread. The quality problems led to complaints and high service and replacement costs.
To avoid further costs, the customer required a complete high-quality drive wheel with a load capacity of six tons. Our solutionThe Blickle Besthane® polyurethane tread of the Blickle wheel series GB and the stable, customized wheel centre made of cast iron offers a good stability and a low rolling resistance, so that the electric transport vehicles achieve a longer service life due to the higher efficiency. With a wheel diameter of only 340 mm and a load capacity of 6 tons per wheel, the customized drive wheel easily fits under the flat substructure of the vehicles.The resultWith the Blickle complete solution in higher quality, this customer was able to drastically reduce procurement costs, delivery times and follow-up costs.